Shopping Basket
-
COOL WHITE SMD STRIP....(1)
-
COOL WHITE SMD STRIP....(1)
-
NEW REPLACEMENT LED ....(1)
-
REPLACEMENT BRIGHT L....(1)
-
GU10 230VOLT 9SMD L....(1)
-
GU10 230VOLT 9SMD L....(1)
-
CLIMB STOPPER LADDER....(1)
-
WARM WHITE SMD STRIP....(1)
-
LIQUID BACTERIA ODOU....(1)
-
B22 BAYONET LED 230 ....(1)
-
S Steel SPOT LIGHT W....(1)
-
WARM WHITE SMD STRIP....(1)
LED BULBS
-
-
- MINI BAYONET BA9S SINGLE BULB BA9S
- A MINI BAYONET BULB FOR MARKER LIGHTS ETC. ESPECIALLY RECOMMENDED FOR MARINE USE,BOAT MARKERS , AMERICAN RV'sETC GIVING OUT APPROX 10w LIGHT USING LESS THAN 1 WATT
Size: 3cm LONG ( tip to top) 8mm wide ( bayonet) level pins
1cm wide top.
-
GBP5.05
- Add To Basket
-
-
- MINI BAYONET BA9S TRIPLE BULB PACK BA9T
- A MINI BAYONET BULB FOR MARKER LIGHTS ETC. ESPECIALLY RECOMMENDED FOR MARINE USE,BOAT MARKERS , AMERICAN RV'sETC GIVING OUT APPROX 10w LIGHT USING LESS THAN 1 WATT
Size: 3cm LONG ( tip to top) 8mm wide ( bayonet) level pins
1cm wide top.
-
GBP14.15
- Add To Basket
-
-
- MINI G4 SMD SINGLE BULB MG4S
- REPLACES A G4 HALOGEN BULB, 9SMD CHIPS, SUPERB FOR THOSE LAMPS THAT REQUIRE A SLIM DESIGN FOR CONSTRICTED AREAS.
APPROX 18 WATTS LIGHT OUTPUT, ONLY 1 WATT POWER.
WARM WHITE LIGHT
Size. 3cm LONG ( top to tip) 1cm Wide. pins 4mm apart
-
GBP8.51
- Add To Basket
-
-
- MINI G4 SMD TRIPLE BULB PACK MG4T
- REPLACES A G4 HALOGEN BULB, 9SMD CHIPS, SUPERB FOR THOSE LAMPS THAT REQUIRE A SLIM DESIGN FOR CONSTRICTED AREAS.
APPROX 18 WATTS LIGHT OUTPUT, ONLY 1 WATT POWER.
WARM WHITE LIGHT
Size. 3cm LONG ( top to tip) 1cm Wide. pins 4mm apart
-
GBP21.44
- Add To Basket
-
-
- LED DRIVER 230V - 12 VOLT DC
- AN LED DRIVER DESIGNED TO REDUCE 230v TO 12 VOLT DC VOLTAGE SUITABLE FOR ALL LED BULBS INCLUDING STRIP TAPE.
MEASURES JUST 9cmL x 4cmW x 2cmH
OUTPUT 12 WATTS MAX
-
GBP10.98
- Add To Basket
-
-
- 1156 ADAPTOR UNIT ADAP01
- THIS UNIT HAS BEEN DESIGNED FOR CONVERTING SOME OLDER EYEBALL LIGHTS THAT USE 1156 ( car indicator bulb ) TO ACCEPT MR11 and G4 LED BULBS. SOME OLDER UNITS WILL NOT ACCEPT OUR 1156 REPLACEMENT BULBS DUE TO THE WIDER SHOULDER PREVENTING THE BULB TO SEAT PROPERLY. THIS ADAPTOR SOLVES ALL PROBLEMS.
-
GBP3.06
- Add To Basket
-
-
- 1156 ADAPTOR UNIT ADAP03 THREE PACK
- THIS UNIT HAS BEEN DESIGNED FOR CONVERTING SOME OLDER EYEBALL LIGHTS THAT USE 1156 ( car indicator bulb ) TO ACCEPT MR11 and G4 LED BULBS. SOME OLDER UNITS WILL NOT ACCEPT OUR 1156 REPLACEMENT BULBS DUE TO THE WIDER SHOULDER PREVENTING THE BULB TO SEAT PROPERLY. THIS ADAPTOR SOLVES ALL PROBLEMS.
-
GBP8.81
- Add To Basket
-
-
- 1157 ADAPTOR UNIT SINGLE UNIT ADAP701
- THIS ADAPTOR IS FOR USE IN LIGHT FITTINGS THAT REQUIRE A DOUBLE CONTACT SINGLE FILAMENT BULB ( AMERICAN RVs ETC). THE UNIT CONVERTS THE LAMP TO A TWO PIN UNIT ENABLING A LARGE COMBINATION OF OUR LED/SMD TO FIT
-
GBP3.51
- Add To Basket
-
-
- 1157 ADAPTOR UNIT TRIPLE PACK ADAP703
- THIS ADAPTOR IS FOR USE IN LIGHT FITTINGS THAT REQUIRE A DOUBLE CONTACT SINGLE FILAMENT BULB ( AMERICAN RVs ETC). THE UNIT CONVERTS THE LAMP TO A TWO PIN UNIT ENABLING A LARGE COMBINATION OF OUR LED/SMD TO FIT
-
GBP10.21
- Add To Basket
-
-
- 12 SMD AWNING BULB
- A SUPERB ULTRA BRIGHT BULB USING THE 1156 SINGLE CONTACT BAYONET FITTING ( CAN BE CUT OFF AND THE WIRED INTO ANY 12V SOURCE). 23 WATTS LIGHT OUTPUT, JUST 1.3 WATTS POWER CONSUMPTION. SIZE4CM SQUARE.
AVAILABLE IN WARM WHITE AND ULTRA WHITE LIGHT
-
GBP9.50
- Add To Basket
-
-
- AWNING LIGHT BOARD
- 28WATTS LIGHT, 1.5WATTS POWER. 12 SUPER INTENSE WHITE SMD CHIPS. 1156 BAYONET CAP OR CAN BE CUT OFF AND CONNECTED TO ANY 12V POWER SOURCE. SIMPLY REPLACE EXISTING BULB AND USE STICKY FOAM PADS ( not supplied ) TO INSIDE OF LAMP UNIT.
Dimensions 4cm square, 5mm deep, 8cm wires to 15mm bayonet cap
-
GBP9.50
- Add To Basket
-
-
- COOL WHITE SMD STRIP TAPE 0.5MT
- THIS STRIP TAPE CONTAINS 30 SMD LEDS PER 0.5MT LENGTH. THE TAPE IS SELF ADHESIVE AND IS USED AS A REPLACEMENT FOR THE FLOURESCENT LAMPS ON THE TOP OF CUPBOARDS ETC. SIMPLE TO INSTALL JUST REQUIRING A 12V FEED. SIMPLY DISCONNECT YOUR TOP CUPBOARD LIGHTS AND USE THEIR POWER FEED TO POWER THIS TAPE.
WARM WHITE 1MT LONG. CAN BE CUT. WATERPROOF.
- Offer price GBP15.27
- Add To Basket
-
-
- COOL WHITE SMD STRIP TAPE 1MT
- THIS STRIP TAPE CONTAINS 60 SMD LEDS PER 1MT LENGTH. THE TAPE IS SELF ADHESIVE AND IS USED AS A REPLACEMENT FOR THE FLOURESCENT LAMPS ON THE TOP OF CUPBOARDS ETC. SIMPLE TO INSTALL JUST REQUIRING A 12V FEED. SIMPLY DISCONNECT YOUR TOP CUPBOARD LIGHTS AND USE THEIR POWER FEED TO POWER THIS TAPE.
WARM WHITE 1MT LONG. CAN BE CUT. WATERPROOF.
- Offer price GBP28.78
- Add To Basket
-
-
- WARM WHITE SMD STRIP TAPE 0.5 MT
- THIS STRIP TAPE CONTAINS 30 SMD LEDS PER 0.5MT LENGTH. THE TAPE IS SELF ADHESIVE AND IS USED AS A REPLACEMENT FOR THE FLOURESCENT LAMPS ON THE TOP OF CUPBOARDS ETC. SIMPLE TO INSTALL JUST REQUIRING A 12V FEED. SIMPLY DISCONNECT YOUR TOP CUPBOARD LIGHTS AND USE THEIR POWER FEED TO POWER THIS TAPE.
WARM WHITE 1MT LONG. CAN BE CUT. WATERPROOF.
- Offer price GBP15.27
- Add To Basket
-
-
- WARM WHITE SMD STRIP TAPE 1MT
- THIS STRIP TAPE CONTAINS 60 SMD LEDS PER 1MT LENGTH. THE TAPE IS SELF ADHESIVE AND IS USED AS A REPLACEMENT FOR THE FLOURESCENT LAMPS ON THE TOP OF CUPBOARDS ETC. SIMPLE TO INSTALL JUST REQUIRING A 12V FEED. SIMPLY DISCONNECT YOUR TOP CUPBOARD LIGHTS AND USE THEIR POWER FEED TO POWER THIS TAPE.
WARM WHITE 1MT LONG. CAN BE CUT. WATERPROOF.
- Offer price GBP28.78
- Add To Basket
-
-
- T10 501 WEDGE LED ADAPTOR SINGLE
- THIS ADAPTOR CONVERTS T10 501 FITTINGS TO ACCEPT TWO PIN STANDARD LED BULBS
-
GBP3.51
- Add To Basket
-
-
- T10 501 WEDGE LED ADAPTOR TRIPLE PACK
- THIS ADAPTOR CONVERTS T10 501 FITTINGS TO ACCEPT TWO PIN STANDARD LED BULBS
-
GBP10.21
- Add To Basket
-
-
- T10 501 WEDGE 6SMD BULB SINGLE
- THIS WEDGE BULB IS IDEAL FOR MARKER LIGHTS. APPROX 6 WATTS WARM WHITE LIGHT USING 0.5WATTS POWER
-
GBP4.59
- Add To Basket
